Western Auto Revelation Model 120
- Western Auto 22 Revelation Model 120
- Western Auto Revelation Model 120 Parts
- Western Auto Revelation Model 120
Guy has a Western Auto 'revelations' model 100 single shot bolt action rifle, good condition with some bluing wear on the top of the barrel. Stock finish is good, functions with no problems. I'm not familiar with these so figured I'd ask to see if anyone has a ballpark figure so I can see what sort of value it may have.
I was given this old tube-fed .22 by my Dad. It has some problems. It outshoots modern off-the-shelf 10/22 and Remington 597 by good bit, so I thought this old pea shooter would be worth repairing.It looks like the stock was very cheaply manufactured, with a lot of extra room that shouldn't be there for the receiver and trigger assembly. At some point, someone cranked down the screws on the trigger assembly enough to break it. I don't expect anyone to know of a replacement part for something this old (although it would certainly be nice...) but am open to any suggestions as to how to easily repair it better that I already have.
Western Auto 22 Revelation Model 120
- The Revelation 120 was sold by Western Auto and is basically a Marlin model 60. These rifles have a rather complicated action which is difficult at best when it has to be completely disassembled. A task definitely best left to experienced gunsmiths.
- Western Auto Model 120 Revelation (Marlin Model 99) 22 Lr Semi-Auto Rifle - 11646745 Buyer Tip: Seller assumes all responsibility for listing this item. If you have any questions regarding this item, you should contact the Seller before bidding.
The front mounting screw hole for the trigger assy is also broken so that the head of the screw passes through freely:
I have rebuilt the interior of the stock using an epoxy putty. I put a layer of saran wrap between the receiver and the stock and put it in place. I pushed blobs of epoxy putty up into the vacant spaces from the bottom, then put more plastic wrap over it and pushed the trigger assembly into place to what looked like the proper position. I smeared the screws with grease to keep the epoxy from sticking, and loosely screwed them in. After setting the opening looks like this:
the rifle is currently fuctional, but the trigger is held in place by only the single remaining good screw.Ideas?